Portfolio

Portfolio Continued

Two-wheeled self-balancing robot with an ESP32-S2 board and IMU on top of a 3D-printed chassis

Self-balancing robot

In progress

Parts
ESP32-S2, ICM42688 IMU over SPI, L298N motor driver (HW-095 board), 3D-printed chassis
How it estimates tilt
A complementary filter blends the gyro and accelerometer (alpha 0.98). Control runs at about 100 Hz, and the motors cut off past 35° of tilt.
Works now
Sensor reads and the control loop
Not yet
PID tuning
Next step
Log the tilt estimate (accelerometer only, gyro only, blended) while tilting it by hand, and post the plot.
Stewart platform on a desk: six stepper motors on a gray base plate, linked by rods to a hexagonal top plate

Stewart platform

In progress

What it is
Six-axis motion platform. 250 mm base radius; 110 mm and 220 mm links.
Parts
Arduino Mega, six NEMA steppers on DRV8825 drivers, hand-soldered driver board
Works now
Homing
Next step
Inverse kinematics: turning a desired platform position into six motor positions
Timeline
Driver board soldered by May 2024; platform assembled December 2025
Solder side of the hand-soldered stepper driver board, held in a hand
Solder side of the driver board
SO-101 follower arm folded at rest on a desk: dark gray 3D-printed links, black servos and red, white and black servo cables

SO-101 open-source robot arm

In progress

What it is
Open-source arm with five joints and a gripper, driven by STS3215 servos, to be mounted on a TurtleBot3 Burger that is being expanded into a Waffle
Works now
Follower arm built
Next step
Train generalizable grasping and manipulation on the real arm, then in simulation
After that
Train the same way with the arm mounted on the TurtleBot3
Render of the SO-101 URDF model with the arm raised and the gripper open
SO-101 URDF model
White box with a large round button embossed with the word NOPE

NOPE button

Complete 1-day build

A one-day build and a joke gift for a hacker white-elephant exchange: an ESP32-S2 that acts as a USB keyboard. Each press types a randomly chosen message to an AI coding agent: press once to push back, twice to refine, hold to start over.

Single press
“This smells like overengineering wearing a fake mustache. Find the unnecessary complexity and remove it.”
Double press
“This works in the demo universe. Make it survive Earth.”
Long press
“This is no longer software; it is a haunted lasagna. Start over with fewer layers.”
CAD render of the induction heating coil mount on the torch at the end of a robot arm

Induction heating coil mount for WAAM process

Faculty research with Dr. Bishal Silwal

Design of an induction heating coil to preheat the filler material in wire arc additive manufacturing (WAAM), in order to observe the impact on magnetic arc blow.

EMG Animatronics Testing

Hobby

Skills used most
Arduino coding, 3D printing, CAD design (SolidWorks), GPIO integration
Tools
MyoWare muscle sensor, Arduino Uno, CR-10 Mini 3D printer, servos, Arduino IDE
CAD render of two servos on a mount on a round base
Servo mount (CAD)
CAD render of the nano-fiber spinning apparatus: a bowl under a clear dome, on a frame with a control panel

Mechanical Nano-Fiber Spinning Apparatus

Academic

Collage of four hobby projects: a rose music box, a Spider-Man phone case, a Raspberry Pi case and an electric skateboard
Rose music box · Spider-Man phone case · Raspberry Pi case · Electric skateboard